Currently (v0.17…), damage can only be marked on deployed units and in the combat screen.

Manually Mark / Edit Dot Damage

aka. ‘Dumb marking’ or ‘the marking behavior of Flechs Sheets when a sheet’s automations are not enabled’.

1. Click a unit name to open its details view.
2. Tap armor or internal panel. (Note the ‘✏️ Edit’ tool-tip.)
3. Select the amount of damage to add or remove.

manual-marking.mp4

<aside> ✏️

Manual Marks / edits…

• Will not trigger damage transfer, critical hits, conscious checks, or other game events.

• Will update derived statuses, e.g., whether or not a location is destroyed, piloting skill check target numbers.

• May affect declared attacks:

  • Added damage never affects declared attacks. Added damage is treated as damage from the damage step of the attack phase, which technically occurs after that phase’s attack to-hits are resolved, per the rules as written.
  • Removed damage may affect declared attacks if the removed damage was from a previous phase.

• 🔥 May be made at any time, even in the middle of resolving a game event. (This also applies to other edits made on the unit details screen.)

  edit-damage.mov

</aside>

Resolve / Input a Damage Group

aka. ‘Mark damage with automations’ or ‘the marking behavior in Flechs Sheets when a sheet’s automations are enabled’.

From Combat Screen

1. Tap the armor/internal numbers on a location.
2. Enter the size of the damage group to apply

automated-marking.mp4

(For rear torso strikes, tap the lower armor number.)

rear-strike.mp4